Trimble Condor Family

• GPS L1 Frequency C/A Code Receiver
• NMEA Output and Input
• SBAS (WAAS, EGNOS) Capable
• aGPS Capable
• Update Rate up to 5 Hz
• PPS Timing Output
• Available in Kit and Module forms
• Supports NMEA protocol

Copernicus II Modul

• 2.54 mm T x 19 mm W x 19 mm L
• Tape & reel packaging
• Supports SBAS (WAAS, EGNOS)
• Active or passive antennas
• NMEA, TSIP, TAIP protocols
• RoHS-Compliant (Pb-free)
• Available in kit and PCB module forms
• Supports both NMEA,TSIP and TAIP protocols

LassenDR+GPS Module

• DR positioning solution with integrated GPS receiver
• Available in kit and PCB module forms
• Supports both NMEA and Trimble binary protocols
• Automatic calibration of external sensor inputs
• Instantaneous and accurate positions in deep urban canyons
• Continuous position outputs in tunnels, parking garages and on lower bridge

Lassen IQ

• Ultra-low power: 86 mW
• Trimble quality at low cost
• Aided GPS through TSIP for faster acquisition
• Dual sensitivity modes with automatic switching
• 12-channel simultaneous operation
• Supports NMEA 0183, TSIP, TAIP and DGPS
• RoHS-Compliant (Pb-free)

Lassen SQ

• 110 mW @ 3.3V
• 26 mm x 26 mm x 6 mm
• TSIP, TAIP and NMEA 0183 protocols
• Flash memory
• Small companion antenna: 20.1 mm x 20 mm x 8 mm
• Antenna short-circuit detection and protection
• RoHS-Compliant (Pb-free)

Zelia Modul

• Dimensions: 16.0 mm x 36 mm (not including connector)
• Connector: 3.2 mm x 12 mm
• Dimensions including connector: 19.2 mm x 36 mm
• Interface Connector: 0.8 pitch, 1 mm thick
• Mating Connectors: Vertical socket P/N : SAMTEC MEC8-110-01-L-DV
• Right angle socket P/N: SAMTEC MEC8-110-01-L-D-RA1

Silvana und Anapala

• Dimensions: 35.56 x 35.56 x 8 mm
• Weight: 17 g (Silvana with SMA)
• Weight: 15 g (Silvana with U.FL and Anapala)
• U.FL or Female SMA (Silvana ACM only)
• Interface: 22-pin Socket SAMTEC CLP-111-02-G-D-T
• Mating Connectors Straight Header, SAMTEC # FTSH-111-03-L-D
• 90° Header, SAMTEC # FTSH-111-02-L-DH-RA